When you are learning how to vacuum an inground pool, there are some things that you will want to know about in order to get the best results. When you are cleaning an inground pool, you will have to use a pool cleaner, or power washer, which is a good way to clean the pool because they have suction that can get into the small spaces that most cleaners cannot get into. One thing that people do not realize when they are learning how to vacuum an inground pool is that a good pool filter can actually cut down on the amount of algae and germs that are in the pool. When people notice that there are more germs and algae in their pool, they usually call the pool technician to clean it or they will clean it themselves. The thing that you will want to know is how to vacuum an inground pool without cutting down on the pool’s filter, so that you can enjoy swimming in it for many years to come.
So, if you are interested in learning how to vacuum an inground pool, the first thing that you will want to do is remove the decking from around the pool. This is also known as the pool liner. Once you have done this you will have to get rid of the debris that has built up in the pool, as well as any dirt or objects that are in the filter. The main thing that you want to be careful about when removing the decking is not to damage your filter. You do not want to have to replace the filter before the inground pool is even used, and if you do accidentally damage the filter you might have to start over and purchase a new one, which can end up being more expensive than getting the pool cleaned completely. So, if you see any signs of wear or damage you will want to take the pool filter off immediately, so that you do not have any water leaking into the pool.
Once you have taken all of the debris out of the pool you will be ready to get started on how to vacuum an inground pool. Start by draining the water out of the pool so that you will be able to see what is left in the bottom of the pool. If there is any dirt or other items in the pool, you will need to get these out as well. If there are any rocks in the bottom of the pool, you will need to remove these as well, and if you see any metal or steel pipes, you will have to either cut them out with a garden tool, or you will have to remove them with a wet/dry vac.
As soon as you have drained the pool you will need to check the condition of the filter. In general you will want to add some type of conditioner to the filter, and depending on the size of the filter you may need to purchase some conditioner as well. Make sure that you follow any instructions that come with your pool cleaner, and read the manual carefully.
Now that you have your filter in good working order you will need to test the system again, and make sure everything is running properly. This will require taking apart the filter, removing the pump, and testing the water flow to make sure that you are getting the best amount of water through the filter. If you do not test the system, you may end up with a clogged filter which can be very dangerous for you and your children, especially while swimming. When you test the system you will need to make sure that the water flows smoothly through the filter, and that there is no resistance as this can be a cause for the clogging of the filter.
Once you have completed your test, you will know how to vacuum an inground pool. When you are done vacuuming turn off the pump and remove the filter from the system. You should then rinse off the pool cleaner fully with water. When you are finished rinsing the pool cleaner you will want to dry it out, this can be done by leaving it in the sun or setting it outside to dry. Once you have completed this step, you are now ready to install your pool cleaner in your inground pool.